|
Technical Specs: EpoxyGator®
Plastic Stick
Two component, ready to use simply by cutting amount desired, kneading
by hand to a uniform consistency and apply. Bonds tenaciously to
plastic. Plastic Stick epoxy putty will bond to most major
plastics.
● Excellent for all plastic repairs.
● Non-Shrink Properties
● Can be drilled, tapped, sanded, sawed, machined, sculpted and even painted
● Fill crack voids, holes, gouges.
● Repair auto moldings/trims, broken plastic parts, PVC furniture, toys
etc.
● Seal leaks in PVC pipes and ABS pipes
● Excellent for hard or flexible plastics parts
● Contains no solvents, thus non-flammable
Directions for use:
Area must be clean and free of oils and dirt. For best results use
a wire brush to scratch the surface to ensure proper bonding. If
any oil is present, please wash/wipe it away using a solvent or cleaner.
Cut the desired amount using a knife. Mix by kneading to a uniform
consistency. All our epoxy putty sticks are two component and are
conveniently colored. While mixing make sure both colors have
blended well. Cooler weather will make the epoxy hard to mix.
Simply heat up the epoxy stick until room temperature and use.
After mixing, immediately apply within 2 minutes to the area. During
the curing phase, material can be smoothed using slight damp fingers.
Wash hands with soap and water after use.
Pot Life: Approximately 15 minutes depending upon ambient temperature
Initial Cure: 30 minutes to harden
Full Cure: 180 minutes
Shelf Life: 1.5 Years Unopened Containers
Compressive Strength: 10,500 lbs p.s.i
Shrinkage: <1
VOC Content: 0%
Operating Temperature: 300 F
Chemical Resistance: Resistant to all general MRO liquids.
Please contact 516-624-9774 for Chemical Resistance Chart
Packaging: Sizes available: 2oz (Length 3.5 Inches) & 4oz.
(Length 7 1/8 Inches)
Cured Color: WHITE
WARNING: May be a skin irritant to person with sensitive skin. Such
person should use gloves and wash hands after use. This material
is an eye irritant. Please use protective goggles when using this
product. Accidental entry to eye occurs, please flush with cold
water and contact your physician. Read M.S.D.S before using any chemical
products in your facility and follow OSHA safe standards and house hygiene practices. |
